Battery Conditioners

CTEK XS 0.8

The CTEK XS 0.8 battery conditioner uses the same PRIMARY SWITCHED electronics to make it the most advanced conditioner available today. The CTEK XS 0.8 is designed for keeping good batteries in good condition. Your battery should have a minimum of 8v in order for it to tell the conditioner what is required. The conditioner constantly monitors the voltage after it has charged the battery to 14.4v and then only pulse’s the battery when the voltage drops to 95% efficiency due to alarms or natural drainage. This eliminates the danger of over charging the battery allowing it to be left connected for many months at a time. The CTEK XS 0.8 will charge the battery to 95% at 0.8 amps, it will then reduce its input current to 0.4 amps to slowly bring the battery to its maximum voltage before turning off and waiting for the battery to fall to 95% efficiency (approx 12.9v) when it will turn on again and condition the battery back to 100%.

* Designed for 12 Volt Battery – Conditioner.
* Free connector kit included for difficult to reach batteries.
* Monitors voltage and turns on & off automatically.
* Can be used without disconnecting the car electrics.
* Suitable for use on batteries from 1.2Ah to 100Ah.
* Can charge negative & positive earth vehicles.

Price £45.00 inc VAT, P&P by Royal Mail £5.00 inc VAT total £50.00

 

CTEK MXS 3.8

The Multi MXS battery charger is the first PRIMARY SWITCHED charger of its kind. his allows it to charge at a higher rate without gassing or damaging vehicle electrics with spikes of power. The CTEK MXS 3.8 has combined all the benefits of a trickle / float with the power of a conventional charger. The important factor is that the Multi MXS constantly monitors the voltage after it has charged the battery, and then only pulse’s the battery when the voltage drops due to alarms or natural drainage. This eliminates the danger of over charging the battery.

The Multi MXS has three charging modules, its ‘bulk’ mode will charge a flat battery up to 85% efficiency then switch to ‘absorption’ mode when it conditions the battery at a constant voltage to almost 100%, then switches to ‘pulse’ mode, at this point it is monitoring the voltage, if the voltage falls to 95% it will pulse the battery back to 100%.

Primary switched technology allows faster safer charging without gassing. Designed to be left connected for long periods. Suitable for use on batteries from 1.2Ah to 120Ah. Supplied with connection kit for difficult to reach batteries. Maximum charge voltage of 14.7v – 3.6amps.

Functions
Auto: Fully automatic for optimal charging
12V: For all lead-acid batteries
Step 6: Fully Charged Battery
Step 7: Maintenance Charging
COLD/AGM: Charging in cold conditions and AGM batteries
SMALL: Program for charging small batteries
NORMAL: Program for charging normal batteries

* Designed for 12 Volt Battery – Charger and Conditioner.
* Free connector kit included for difficult to reach batteries.
* Monitors voltage and turns on & off automatically.
* Can be used without disconnecting the car electrics.
* Can charge negative & positive earth vehicles.
* Waterproof case for vehicles kept outside.

Price £70.00 inc VAT, P&P by Royal Mail £5.00 inc VAT Total £75.00

 

CTEK MXS 5.0

CTEK MULTI MXS 5.0 is smarter, better and safer than any other consumer charger yet seen. This third generation charger has more features and more safety features than any other charger in this segment. MULTI MXS 5.0 is a fully automatic 8-step switch mode charger. Extremely powerful and delivers 0.8A to 4A max. MULTI MXS 5.0 is suitable for both advanced charger applications and the more general applications for cars, motorcycles, jet skis, snowmobiles, or other vehicles using small or medium-size lead batteries. All CTEK battery chargers are electronic proof, non-sparking and reverse polarity and short circuit proof.

The MULTI MXS 5.0 model offer several alternative settings to suit specific charging needs and required functionality. The following recommendations should only be regarded as guidelines. Please observe the battery manufacturer recommendations in the event of uncertainty. Settings are made by pressing the “MODE-button” and stepping forward one press at a time until the required mode is reached, the button is then released. After about two seconds the charger activates the selected mode. The selected mode setting will be restored next time the charger is connected.

8 step, fully automatic switch mode battery charger.
Charges lead-acid batteries (Wet, MF, GEL and AGM) from 1.2Ah to 140Ah.
Maintenance pulse charging increases battery life and gives superb performance.
Charges even drained batteries.
Pulse recover of slightly sulphated batteries.
Three unique charging modes for use on small batteries, large batteries and a special cold mode thatis also suitable for AGM batteries.
Low back current drain, low ripple and input voltage independent (220-240V).
Delivered with two interchangeable connection leads, one with clamps, and one with eyelet terminals.
The charger can be connected for months, ideal for seasonal vehicles.
5 year warranty.

Price £90.00 inc VAT, P&P by Royal Mail £7.00 inc VAT total £97.00